SunnySky X2208 KV2600 Brushless Motor
SunnySky brushless motors are made of quality components that are normally only seen in high end products, and are designed to give years of high performance. Every motor has been carefully balanced and tested in the factory.
All SunnySky motors are covered by two year limited warranty.
Every motor comes with a cross type mount and a propeller adaptor as shown in the following photos.
Durable Japanese NMB ball bearings
Efficient Japanese Kawasaki stator steels
Rare earth neodymium magnets stable up to 180 OC
Polyesterimide enameled oxygen free copper wires that work up to 180 OC
CNC machined and anodized aluminum case
Laser-engraved motor model and KV number
Soft silicone wire leads
Patented balance techniques
Stator Diameter .......... 22 mm
Stator Height..............8 mm
Outside Diameter ..........28 mm
Body Length ...............23 mm
Shaft Diameter ............3.0 mm
Motor Kv ..................2600 RPM / Volt
Motor Weight ..............44 g
Accesory Weight...........13 g
SunnySky motors sold by Buddy RC are manufactured by using quality materials and built to last. The motors are covered by a two year limited warranty against defects in materials and workmanship.
Motor bearings, shafts, and propeller adapters are normal wear parts, and as such, need to be maintained and changed periodically. Therefore these parts are not covered by the two year warranty, nor any subsequent damage caused to the motor or aircraft by these wear parts.
For maximum life, we suggest to install motors and accessories properly, and put a small drop of oil on each bearing every 10 flights. If phenomena of motor vibration, shaking, roughness, or notches in bearings are observed after a period of use, it is suggested to replace motor bearings immediately. It is the responsibility of the pilot to ensure that the bearings are maintained properly and periodically. For the best overall combination of performance, quality, and value, use SunnySky brushless motors in your aircrafts.
Motor dimensions (in mm)
Dimensions of motor mount