ZTW 1:8 Beast SS 120A Combo (4P SS 3674B 3.5D)

ZTW 1:8 Beast SS 120A Combo (4P SS 3674B 3.5D)

ZTW 1:8 Beast SL150A Combo

ZTW 1:8 Beast SL150A Combo

ZTW Programming Card A for Car ESCs

$8.99
Availability: In stock
SKU
ZTW-Pcard-ESC
ZTW Programming Card A for  Car  ESCs
ZTW Programming Card A for  Car  ESCs

This programming can be used to program all ZTW Mantis Series brushless ESCs quickly and easily except for the Mantis 6A ESC.
Note: ONLY compatible with ZTW Mantis-Series ESCs. Cannot be used to program ZTW Gecko Series or other ZTW ESCs.
Programmable Options:
Brake setting (off/soft/mid/hard -- default: off)
Battery type: (Ni-XX/LiPo/LiFe -- default: LiPo auto detect)
Low voltage cutoff setting (2.8V / 3.0V / 3.2V / None -- default: 3.0V)
Factory default setup reset Timing settings (auto / 2° / 5° / 8° /15° / 22° /30° -- default: auto)
SBEC output voltage (on 45A and larger models only) (5.0V / 5.5V / 6.0V -- default: 5.0V)
Governor mode (RPM off / 1st soft start / 2nd soft start / gov mod 1 / gov mod 2 -- default: RPM off)
Motor rotation (forward / reverse -- default: forward) vStart-up strength (10% / 15% / 20% / 25% / 30% / 35% / 40% / 45% / 50% -- default: 30%)
Low voltage cutoff type: (reduce power / cut-off power -- default: reduce)
How to Use the LED Program Card:
1.ZTW Program card with LED display is easy to use and convenient to carry. All of the programmable functions are shown on the program card.
2.Turn on the ESC. Remove the signal wire and plug it into the top-socket on the program card wait for 2 seconds until the LED is on.
3.If ESC is not connected with the batteries the program card should be connected with other power supply the range of power supply is from 5.0V to 6.3V.
4.Press the button ”Menu” on the program card and circularly select each programmable function. At that time the number of programmable function will be displayed on the left of the LED the current value will be displayed on the right side. Then press the button “Value” to change the value and press the button “OK” to confirm. At the same time the Red indicating LEDs of both program card and the ESC will blink. Turn off the ESC the modified settings will be saved in the ESC`s memory.
5.Press the button “Reset” to restore the default settings.
Specification:
Dimensions: 70x45x13mm(LxWxH)
Weight: 23g
ZTW-Mantis Series Air ESC programming card
Barcode #  
Continuous Current DC 5.0V~12.0V
Width 45mm
Length 70mm
Height 13mm
Weight 23g
Upgrade Firmware online (Yes/No) no

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account