The kit went together reasonably well, there were no problems in terms of the kit and the parts were of good quality. It's relatively easy to build and work on. I installed KST servos, OMP 2000mA batteries and a 85A Sunnysky ESC from a M4 Max. It feels heavy in the air, which is not what I expected. It flies fast and is not forgiving in maneuvers, I suppose that's typical of a 380 size. It likes high rpms, 2800 seems to be a sweet spot. If you go too low the direct drive motor bogs down and the tail blows out if you ask too much of it. The max collective pitch settings listed in the manual really are maximum. In reality, I'm running like 11.5 to 12 degrees of collective and about 12 degrees of cyclic. Any more than that it overloads the motor. Unless you are running headspeeds of 3200 or so, you are not going to get 300 deg/sec of roll rate. I have tried a few different brands of blades out of curiosity. The RT blades are good for all-around flying but are a bit grabby and punchy. Azure blades are a bit more linear feeling but are a lot like the RTs. I tried some cheap Align blades and it flew just fine even at lower headspeeds. One word of caution is the tail belt tension is crucial. If it is even a little bit too tight it will bog the motor hard and draw a lot of extra current. I saw a video of Jonas doing 3D at 1600 rpm with this thing. I don't know how that's possible. Maybe he really dialed in his FBL setup to get it to respond as good as it did but for me it barely flies at those headspeeds. If you punch the collective or turn quickly at speed it immediately blows the tail, worse than the M4 Max at 1500 rpm. Battery life on this thing is a little better than the M4 Max, which is expected.